Fas-Trak Micro-Trak Plus Floor Finish Applicator
(855) 601-5678 · support@oneupcleaning.com
Finishing a long hallway is the easy part. The time goes into the classrooms, offices, nurse stations and restrooms, where a big applicator can't turn and your crew goes back to a mop, a bucket and a wringer, one room at a time.
The Fas-Trak Micro-Trak Plus is built for those rooms. It's a gravity-fed floor finish applicator with a 1.5 gallon removable tank and a 16-inch microfiber pad. You fill the tank, open the flow, and lay finish down in a thin, even coat. No bucket, no wringer, and nothing strapped to your back.
Fas-Trak rates it at about 8,000 square feet an hour, roughly three times the pace of a mop and bucket, with about 3,000 square feet per fill. Expect less once you count edges, doorways and refills. Even at half that pace, you're well ahead of a mop crew, and the coat goes down more evenly.
Be honest about scale, though. For long corridors, gyms and open floors, the Fas-Trak Ultra-Trak Plus covers up to 25,000 square feet an hour. Plenty of crews run both: the Ultra-Trak in the halls and the Micro-Trak in the rooms off them.
About 8,000 sq ft per hour, three times faster than a mop and bucket by Fas-Trak's numbers, so a summer refinish project takes fewer shifts.
1.5 gallon tank covers about 3,000 sq ft per fill, roughly three 900 sq ft classrooms per coat before you stop to refill.
Compact 16-inch head works into corners, along baseboards and around furniture where wide applicators leave lap marks and buildup.
Handles water-based and solvent-based finishes and sealers, plus gym coatings and other thicker products.
Removable tank means leftover finish goes back into its original container instead of down the drain.
Drip tray included, so you can move between rooms without spotting the fresh coat, then use the same tray for cleanup.
Nothing to charge or plug in. Gravity does the feeding, so there's no pump, battery or cord to fail mid-job.
Not sure it fits your job? Send us your room sizes, floor type and the finish you use, or call (855) 601-5678, and we'll tell you honestly whether the Micro-Trak, the Ultra-Trak or both make sense.
Fas-Trak Industries has made chemical application systems for more than 20 years, and the Micro-Trak Plus is made in the USA. The company lists the United States Postal Service and the Broward County School Board among its customers. See every Fas-Trak machine we carry.
Start with a clean, dry floor that has been stripped or deep scrubbed and rinsed. Fit a clean microfiber pad, fill the tank with finish, and set the unit on its tray until you're ready. Cut in along the walls first, then work in straight, slightly overlapping passes toward the door so you never walk on a wet coat. Let each coat dry as your finish maker directs before the next one.
When you're done, lift out the tank and pour what's left back into the original container. Rinse the tank, valve and manifold with water right away, before finish dries inside them. Fas-Trak's own advice is just as simple for the pad: rinse it with water, or seal it in a plastic bag for the next job.
It fits you best if you run a school or university custodial team, or a cleaning business that refinishes offices, clinics, stores and restrooms. It's the right size for rooms under a few thousand square feet and for the detail work around a larger job.
It only applies finish. You still need a floor machine or an auto scrubber to strip and prep the floor first. And for big, open areas, the Ultra-Trak Plus will save you far more labor.
Upkeep is mostly the rinse after each job. Finish that dries in the valve or manifold is what slows the flow and stiffens the pad. Replacement pads are 100% looped microfiber, sold five to a case under part number FTS-1015. Swap a pad when it stays stiff or starts leaving streaks after rinsing.
Fas-Trak's current warranty policy covers the Micro-Trak Plus for 60 days against defects in workmanship and materials. An older brochure lists one year, so we go by the current policy and tell you up front. Here's our return policy.
| Specifications: Fas-Trak Micro-Trak Plus Floor Finish Applicator | |
|---|---|
| Manufacturer | Fas-Trak Industries |
| Model Number | FT-1800P |
| Type | Single-component, gravity-fed floor finish applicator |
| Application Rate | About 8,000 sq ft/hr (743 m²/hr), Fas-Trak rating |
| Coverage per Fill | About 3,000 sq ft (279 m²) |
| Tank | 1.5 gal (5.7 L), removable |
| Applicator Pad | 5 x 16 in (127 x 406 mm), 100% looped microfiber |
| Dispensing | Aluminum manifold with removable tank and valve assembly |
| Compatible Products | Water-based and solvent-based floor finishes and sealers, gym coatings |
| Power | None required (gravity feed) |
| Overall Size | 16 x 21 x 42 in (406 x 533 x 1067 mm) |
| Included | One microfiber applicator pad and a plastic drip tray |
| Replacement Pads | FTS-1015, 5 per case |
| Made In | USA |
| Warranty | 60 days, defects in workmanship and materials |
Found a lower price? Call or message us and we'll beat it. Questions about finishes, pads or sizing? Call (855) 601-5678, email support@oneupcleaning.com or use the chat, and we'll help you get it right.
Fas-Trak rates a 1.5 gallon fill at about 3,000 sq ft. Your real number depends on the finish and how porous the floor is, so plan a little less on freshly stripped VCT.
Yes. Fas-Trak says it handles water-based and solvent-based finishes and sealers, plus gym coatings and other thicker products. Always follow the coating maker's application instructions.
The Micro-Trak Plus is for classrooms, offices, restrooms and other small rooms, at about 8,000 sq ft per hour. The Ultra-Trak Plus is for long corridors, gyms and open floors, at up to 25,000 sq ft per hour. Many crews use both on the same project.
The Micro-Trak Plus applicator with its 1.5 gallon removable tank, one 16-inch microfiber applicator pad and a plastic drip tray. Extra pads come in cases of five (part FTS-1015).
No. The Micro-Trak Plus feeds finish by gravity through an aluminum manifold, so there is nothing to charge or plug in.
Pour leftover finish back into its original container, then rinse the tank, valve and manifold with water before anything dries. Rinse the pad, or seal it in a plastic bag if you are using it again soon.
Fas-Trak's current policy covers the Micro-Trak Plus for 60 days from purchase against defects in workmanship and materials. Contact us first if something goes wrong and we handle the claim with Fas-Trak.