Tornado builds the Vortex line to clean virtually any hard or soft surface, and lists escalators among them. This escalator pair is the accessory that sets up your Tornado Vortex 13 for that job.
Swap the escalator brushes in when it's time to clean the steps, then swap your floor brushes back for the rest of the building. One compact machine covers the floors and the escalators, with no second machine to buy, store and train on.
If escalators are a big part of your work, compare the Vortex with dedicated machines on our escalator cleaning machines page.
The escalator brushes come as a pair, one for the front shaft and one for the rear. The front brush does most of the scrubbing; the rear brush finishes the job and collects the remaining water, so both are replaced together.
Tornado makes four brush pairs for the Vortex 13:
Swapping Brushes Without Tools
Per Tornado's manual: switch the machine off and unplug it, then pull the two brush shafts. They're held by quick-release retaining balls, so no tools are needed. Slide the brushes off, fit the new pair, and push each shaft back in from the right-hand side of the machine (the side with the power cable and foot pedal), which Tornado notes is the easier way in.
The small multicolored plastic plugs on the brushes are there to identify them, so you can keep a set for each area of a building and avoid carrying soil from one area to another.
Make Your Brushes Last
Wash the brushes regularly. Dip them in a bucket or sink, or rinse them under running water.
Store spare pairs standing vertically so the bristles don't bend.
Don't leave the brushes fitted on a machine that sits idle for days. The bristles take a set in one direction; if that happens, reverse the brush so they can flex back.
Always move the machine in transport mode. Transporting it with the brush control in the working position damages the brushes.
Add the 93049 side brush for edges along baseboards, and the Tornado transport cart for moving the machine between floors. Running the larger Vortex 18? It takes 18 in brushes, such as the escalator pair for the Vortex 18.
Not sure which Vortex you have? Call (855) 601-5678 or send us a message with your machine's model number and we'll confirm the fit. See every Tornado line on our Tornado page.