The soft pair turns your Tornado Vortex 13 into a daily maintenance machine for floors that don't need the bite of the standard brushes. Tornado's price list names it the Soft/Carpet pair.
Tornado's brush chart puts the soft brushes on every maintenance clean of grouted tile, ceramic, mosaic, wood, sports floors, rubber and vinyl tile, once the first deep clean with the standard pair is done. On marble, granite and slate, the chart calls for the soft pair every time, first clean included.
Because the pair is also Tornado's carpet option for the Vortex 13, it's the one to fit for low-moisture cleaning of short pile commercial carpet.
The soft brushes come as a pair, one for the front shaft and one for the rear. The front brush does most of the scrubbing; the rear brush finishes the job and collects the remaining water, so both are replaced together.
Tornado makes four brush pairs for the Vortex 13:
Which Vortex 13 Brush Do You Need?
| Floor |
First-time cleaning |
Maintenance cleaning |
| Grouted tile, ceramic, mosaic, wood, sports floors, rubber, vinyl tile |
Standard |
Soft |
| Short pile carpet |
Soft/Carpet |
Soft/Carpet |
| Marble, granite, slate |
Soft |
Soft |
| Smooth concrete |
Hard |
Standard |
Source: Tornado Vortex 13 operator manual, brush selection chart. Other floors: choose to suit the floor's condition.
Swapping Brushes Without Tools
Per Tornado's manual: switch the machine off and unplug it, then pull the two brush shafts. They're held by quick-release retaining balls, so no tools are needed. Slide the brushes off, fit the new pair, and push each shaft back in from the right-hand side of the machine (the side with the power cable and foot pedal), which Tornado notes is the easier way in.
The small multicolored plastic plugs on the brushes are there to identify them, so you can keep a set for each area of a building and avoid carrying soil from one area to another.
Make Your Brushes Last
Wash the brushes regularly. Dip them in a bucket or sink, or rinse them under running water.
Store spare pairs standing vertically so the bristles don't bend.
Don't leave the brushes fitted on a machine that sits idle for days. The bristles take a set in one direction; if that happens, reverse the brush so they can flex back.
Always move the machine in transport mode. Transporting it with the brush control in the working position damages the brushes.
Add the 93049 side brush for edges along baseboards, and the Tornado transport cart for moving the machine between floors. Running the larger Vortex 18? It takes 18 in brushes, such as the soft pair for the Vortex 18.
Not sure which Vortex you have? Call (855) 601-5678 or send us a message with your machine's model number and we'll confirm the fit. See every Tornado line on our Tornado page.